Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › THROTTLE BODY
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073913 THROTTLE BODY A

2AR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22030 1.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY

a.

Install a new gasket to the intake manifold.


b.

Install the fuel tube bracket with the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


c.

Install the throttle with motor body assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the throttle body connector.


e.

Connect the fuel tube to the clamp.


f.

Connect the No. 2 water by-pass hose to the throttle with motor body assembly.


g.

Connect the water by-pass hose to the throttle with motor body assembly.


Hide 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

a.

Install the air cleaner cap sub-assembly with the 2 clamps.


b.

Install the air cleaner hose with the hose clamp.


c.

Connect the ventilation hose to the cylinder head cover.


d.

Install the fuel vapor feed hose to the air cleaner hose.


e.

Connect the mass air flow meter connector and 2 wire harness clamps to the air cleaner cap sub-assembly.


f.

Connect the vacuum switching valve assembly to the air cleaner hose.


Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 6.PERFORM INITIALIZATION

NOTICE:
·

Be sure to perform this procedure after reassembling the throttle with motor body assembly or removing and reinstalling any throttle body components.

·

Perform the following procedure after replacing the throttle with motor body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.



a.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above step again.



b.

Connect the intelligent tester to the DLC3 and clear the DTCs.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR


c.

Perform the "Inspection After Repair".

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


d.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

Standard:
Condition Engine Idle Speed
A/C switched off 610 to 710 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in N.




e.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data /Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

Powertrain > Engine and ECT > Data List
Tester Display
Throttle Sensor Position
50003 234 12

f.

Perform a road test and confirm that there are no abnormalities.