Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › THROTTLE BODY
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073913 THROTTLE BODY A

2AR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A254779

Disconnect the vacuum switching valve assembly from the air cleaner hose.


b.
A254778

Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.


c.
A254774

Separate the fuel vapor feed hose from the air cleaner hose.


d.
A254777

Disconnect the ventilation hose from the cylinder head cover.


e.
A254775

Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.


f.
A254776

Release the 2 clamps and remove the air cleaner cap sub-assembly.


Hide 22030 3.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

a.
A254781

Disconnect the fuel tube from the clamp.


b.

Disconnect the throttle body connector.


c.
A254780

Disconnect the water by-pass hose from the throttle with motor body assembly.


d.

Disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.


e.
A195069

Remove the 4 bolts and throttle body with fuel tube bracket.


f.
A195070

Remove the bolt and fuel tube bracket.


g.
A195071

Remove the gasket from the intake manifold.