Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073916 MASS AIR FLOW METER G

2AR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedure below.

·

Only replace the mass air flow meter when the mass air flow value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, make sure that an exhaust air duct is not performing suction on the exhaust pipe.



a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON (do not run the engine).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

e.

Wait 30 seconds, and read the values on the intelligent tester.

Standard:
Item Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after turning ignition switch to ON


0.48g/sec. or less


If the results are not as specified, replace the mass air flow meter sub-assembly.

If the results are as specified, inspect the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION