Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › 2011.10–2015.04
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073917 CAMSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Camshaft position sensor (for Intake Side)

i.

Clean and degrease the threads of the bolt for the camshaft position sensor.


ii.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:

Make sure that the O-ring is not cracked or does not jump out of position during installation.



iii.
A192239C48
1.885,1.583 1.802,1.885 1.802,1.885 1.688,1.885 false 1.49,1.802 1.76,1.979 0.271,0.177 10 false *1
*1 Adhesive


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



iv.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


v.

Connect the sensor connector.



b.

Camshaft position sensor (for Exhaust Side)

i.

Clean and degrease the threads of the bolt for the camshaft position sensor.


ii.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:

Make sure that the O-ring is not cracked or does not jump out of position during installation.



iii.
A192239C48
1.885,1.583 1.802,1.885 1.802,1.885 1.688,1.885 false 1.49,1.802 1.76,1.979 0.271,0.177 10 false *1
*1 Adhesive


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



iv.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


v.

Connect the sensor connector.



Hide 2.INSPECT FOR OIL LEAK

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY