Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073920 ENGINE COOLANT TEMPERATURE SENSOR A

2AR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.

Connect the engine coolant temperature sensor connector.


d.

Install the wire harness with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 12260 2.CONNECT VENTILATION HOSE ASSEMBLY

a.

Connect the ventilation hose assembly to the cylinder head cover.


Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY