1.DRAIN ENGINE COOLANT
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY
12260
4.DISCONNECT VENTILATION HOSE ASSEMBLY
Disconnect the ventilation hose assembly from the cylinder head cover.
89422
5.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Remove the 2 bolts and disconnect the wire harness.
| *1 | Ball Joint Lock Nut Wrench |
| *2 | Gasket |
Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
Remove the gasket from the engine coolant temperature sensor.