Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073922 AIR FUEL RATIO SENSOR A

2AR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A254804C04
2.75,0.781 2.604,0.781 2.604,0.781 2.5,2.219 false 1.177,0.865 1.479,1.031 0.302,0.167 10 false *a 1.958,2.844 2.156,3.031 0.198,0.188 10 true *b 2.792,0.688 3.198,0.979 0.406,0.292 10 false SST
*a Fulcrum Length
30 mm
*b Fulcrum Length
300 mm


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

NOTICE:
·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.81 in.).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

The "with SST" torque value is effective when SST is parallel to the torque wrench.



HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



b.

Connect the air fuel ratio sensor connector.


c.

Install the hose clamp.


Hide 2.INSPECT FOR EXHAUST GAS LEAK

Hide 17167 3.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR