25586
1.INSTALL NO. 1 MANIFOLD CONVERTER INSULATOR
Install the No. 1 manifold converter insulator with the 4 bolts.
17168
2.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Install the No. 2 exhaust manifold heat insulator with the 2 bolts.
25051
3.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
Set a new gasket to the cylinder head sub-assembly.
Temporarily install the exhaust manifold converter sub-assembly with the 5 nuts.
Temporarily install the No. 2 manifold stay and manifold stay with the 2 bolts and 2 nuts.
Tighten the 5 nuts in the sequence shown in the illustration.
17167
4.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Install the No. 1 exhaust manifold heat insulator with the 4 bolts.
17139
5.INSTALL NO. 2 MANIFOLD STAY
Install the No. 2 manifold stay with the bolt and nut.
17118
6.INSTALL MANIFOLD STAY
Install the manifold stay with the bolt and nut.
17410
7.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Using a vernier caliper, measure the free length of the compression spring.
| Minimum | 40.5 mm (1.60 in.) |
If the length is less than the minimum, replace the compression spring.
Fully insert a new gasket to the exhaust manifold converter sub-assembly.
| *1 | Exhaust Manifold Converter Sub-assembly |
| *2 | Gasket |
| *3 | Wooden Block |
Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the exhaust manifold converter sub-assembly.
Be sure to install the gasket in the correct direction.
Do not reuse the gasket.
Do not damage the gasket.
Do not push in the gasket by using the exhaust pipe when connecting it.
Install a new gasket to the front exhaust pipe assembly.
Connect the front exhaust pipe assembly to the exhaust pipe support.
Install the front exhaust pipe assembly with the 2 compression springs, 2 bolts and 2 nuts.
Connect the heated oxygen sensor connector.
51441C
8.INSTALL ENGINE UNDER COVER RH
51442C
9.INSTALL ENGINE UNDER COVER LH
53851Z
10.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
53852K
11.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
89467B
12.INSTALL AIR FUEL RATIO SENSOR
13.INSPECT FOR EXHAUST GAS LEAK