Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM19V0EQ _51 Engine / Hybrid System _014574 2AR-FE ENGINE MECHANICAL _0073929 FRONT CRANKSHAFT OIL SEAL A

2AR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.

NOTICE:
·

Do not allow foreign matter to contact the lip of the oil seal.

·

Do not allow MP grease to contact the dust seal.




b.
A195808
0.875,0.25 1.073,0.25 1.073,0.25 1.74,0.792 true 0.51,0.167 0.823,0.333 0.313,0.167 10 false SST

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

SST
09223-22010  

NOTICE:
·

Keep the lip of the oil seal free from foreign matter.

·

Do not tap in the oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.

Align the pulley set key with the key groove of the crankshaft pulley.


b.
A264825
2.146,0.458 2.667,0.521 2.667,0.521 2.198,0.781 false 2.094,0.708 2.667,0.521 false 2.708,0.448 3.021,0.635 0.313,0.188 10 SST 0.99,0.844 1.188,1.031 0.198,0.188 10 *a 2.115,1.792 2.313,1.979 0.198,0.188 10 *b
*a Hold
*b Turn


Using SST, hold the crankshaft pulley and install the pulley bolt.

SST
09213-54015  
09330-00021  

Torque:
260 N*m (2650 kgf*cm, 192 ft.*lbf)

HINT:

SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)



Hide 53736 4.INSTALL FRONT FENDER APRON SEAL RH

Hide 51441C 5.INSTALL ENGINE UNDER COVER RH

Hide 53851Z 6.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

Hide 7.INSTALL FRONT WHEEL RH

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)