Home › Engine / Hybrid System › 2AR-FE INTAKE / EXHAUST › INTAKE SYSTEM › 2011.10–2016.05
RM19V0EQ _51 Engine / Hybrid System _014577 2AR-FE INTAKE / EXHAUST _0073947 INTAKE SYSTEM G

2AR-FE INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

a.

Check that there are no vacuum leaks at the points shown in the illustration.

A264733C01
0.198,0.208 0.865,0.563 0.667,0.354 12 false *A
*A for RHD - -


A264734C01
0.188,0.198 0.854,0.583 0.667,0.385 12 false *A
*A for LHD - -


HINT:

Perform "Inspection After Repair" after repairing air leaks in the intake system.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



Hide 2.INSPECT INTAKE AIR CONTROL VALVE (for ACIS)

a.

Connect the intelligent tester to the DLC3.


b.

Start the engine and turn the intelligent tester on.


c.

Warm up the engine.


d.
A197999

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Intake Control.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the VSV for Intake Control
50004 234 3

e.

When "Activate the VSV for Intake Control" is turned on, check that the actuator rod operates.

If the operation is not as specified, inspect the intake air control valve, vacuum tank and check valve.

Click hereEngine / Hybrid System>2AR-FE INTAKE / EXHAUST>INTAKE MANIFOLD>INSPECTION


f.

When "Activate the VSV for Intake Control" is turned off, check that the actuator rod returns to its original position.

If the operation is not as specified, inspect the intake air control valve and vacuum hose.

Click hereEngine / Hybrid System>2AR-FE INTAKE / EXHAUST>INTAKE MANIFOLD>INSPECTION