Home › Engine / Hybrid System › 2AR-FE COOLING › RADIATOR › 2011.10–2015.04
RM19V0EQ _51 Engine / Hybrid System _014578 2AR-FE COOLING _0073959 RADIATOR A

2AR-FE COOLING  RADIATOR  INSTALLATION  


PROCEDURE

Hide 16400 1.INSTALL RADIATOR ASSEMBLY

a.
A265690C01
2.208,1.844 1.729,2.052 false 1.115,1.844 1.51,2.031 false 1.542,1.958 1.844,2.167 0.302,0.208 10 false *a
*a Guide


Install the fan assembly to the radiator with the 2 guides at the bottom and 3 claws on the top.


b.

Install the 2 lower radiator supports to the radiator assembly.


c.
A255846

Install the radiator with fan assembly.

NOTICE:

Do not apply any excessive force to the cooler condenser assembly or pipe when installing the radiator assembly.



d.

Install the condenser assembly with the 4 bolts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


e.

Connect the 2 connectors and the 2 clamps.


Hide 53216A 2.INSTALL UPPER RADIATOR SUPPORT

a.

Install the 2 radiator support cushions to the radiator assembly.


b.

Install the upper radiator support with the 5 bolts and connect the hood lock control cable clamp to the upper radiator support.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


c.

Connect the 2 connectors. (for LHD)


d.

Connect the connector. (for RHD)


Hide 53510 3.INSTALL HOOD LOCK ASSEMBLY (for LHD)

Hide 53510 4.INSTALL HOOD LOCK ASSEMBLY (for RHD)

Hide 32942 5.CONNECT OUTLET NO. 1 OIL COOLER HOSE (w/ Oil Cooler)

a.

Connect the outlet No. 1 oil cooler hose.


Hide 32941 6.CONNECT INLET NO. 1 OIL COOLER HOSE (w/ Oil Cooler)

a.

Connect the inlet No. 1 oil cooler hose.


Hide 16572D 7.CONNECT NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose and clamp.


Hide 16571C 8.CONNECT NO. 1 RADIATOR HOSE

a.

Connect the No. 1 radiator hose.


Hide 16470 9.INSTALL RADIATOR RESERVE TANK ASSEMBLY

a.

Install the radiator reserve tank with the 2 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


b.

Connect the radiator reserve tank hose.


Hide 17750A 10.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 11.INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51442C 15.INSTALL ENGINE UNDER COVER LH

Hide 51441C 16.INSTALL ENGINE UNDER COVER RH

Hide 53852K 17.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851Z 18.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH