Home › Engine / Hybrid System › 2AR-FE LUBRICATION › LUBRICATION SYSTEM
RM19V0EQ _51 Engine / Hybrid System _014579 2AR-FE LUBRICATION _0073961 LUBRICATION SYSTEM G

2AR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL LEVEL

a.

Warm up and stop the engine, and then wait 5 minutes.


b.

Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.

If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill the engine with oil to above the full level mark.



Hide 2.INSPECT ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter.


Hide 3.INSPECT OIL PRESSURE

a.

Remove the oil pressure switch assembly.

Click hereEngine / Hybrid System>2AR-FE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL


b.
A209392
0.823,0.5 1.563,0.365 true 1.615,0.292 1.948,0.563 0.333,0.271 10 false *1
*1 Oil Pressure Gauge


Install an oil pressure gauge with the adapter.


c.

Warm up the engine.


d.

Measure the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idle 30 kPa (0.3 kgf/cm2, 4.4 psi) or more
4000 rpm 260 kPa (2.7 kgf/cm2, 38 psi) or more



e.

Remove the oil pressure gauge with the adapter.


f.

Install the oil pressure switch assembly.

Click hereEngine / Hybrid System>2AR-FE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION