1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
2.REMOVE TORQUE CONVERTER ASSEMBLY
35106D
3.REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
Remove the 19 bolts and automatic transaxle oil pan sub-assembly from the transaxle case sub-assembly.
Some fluid will remain in the automatic transaxle oil pan sub-assembly. Remove all the bolts, and carefully remove the automatic transaxle oil pan sub-assembly.
35168A
4.REMOVE AUTOMATIC TRANSAXLE OIL PAN GASKET
Remove the automatic transaxle oil pan gasket.
35394
5.REMOVE TRANSMISSION OIL CLEANER MAGNET
| *1 | Transmission Oil Cleaner Magnet |
Remove the 2 transmission oil cleaner magnets from the automatic transaxle oil pan sub-assembly.
Examine particles in the automatic transaxle oil pan sub-assembly.
Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the automatic transaxle oil pan sub-assembly and on the transmission oil cleaner magnets to see the type of wear which might be found in the automatic transaxle assembly.
| Steel (magnetic) | Brass (non-magnetic) |
|---|---|
| Bearing, gear and plate wear | Bushing wear |
35330
6.REMOVE VALVE BODY OIL STRAINER ASSEMBLY
Remove the 2 bolts and valve body oil strainer assembly from the transmission valve body assembly.
Remove the O-ring from the valve body oil strainer assembly.
35410
7.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
Remove the 11 bolts and transmission valve body assembly from the transaxle case sub-assembly.
When removing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and the transaxle case sub-assembly to interfere with each other.
35148
8.REMOVE NO. 1 GOVERNOR APPLY GASKET
Remove the 2 No. 1 governor apply gaskets from the transaxle case sub-assembly.
35418
9.REMOVE MANUAL VALVE
Remove the manual valve from the transmission valve body assembly.