If automatic transmission parts are replaced, refer to the Parts Replacement Compensation Table to determine if any additional operations are necessary.
Click hereDrivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
43420
2.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
43420G
3.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH
43410
4.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
51100G
5.REMOVE FRONT FRAME ASSEMBLY
82824
6.REMOVE WIRING HARNESS CONNECTOR
Disconnect the wire harness clamp.
Turn the lock lever and disconnect the connector from the wiring harness connector.
Remove the 2 bolts and wiring harness connector from the automatic transaxle assembly.
7.SEPARATE WIRE HARNESS
Remove the bolt and ground cable.
Separate the park/neutral position switch connector and 7 wire harness clamps.
30500
8.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
Using the transmission jack attachment, set the automatic transaxle assembly on a transmission jack.
Secure the automatic transaxle assembly to the transmission jack using a suitable adapter, such as a rope or attachment.
To prevent the oil pan from deforming, do not place any attachments onto the oil pan of the automatic transaxle assembly.
Hold the engine assembly with a suitable adapter, such as a rope, during the operation.
Remove the 9 bolts and automatic transaxle assembly.
To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine.
33493A
9.REMOVE TRANSMISSION OIL COOLER (w/ ATF Warmer)
| *1 | No. 1 Oil Cooler Inlet Hose |
| *2 | No. 1 Oil Cooler Outlet Hose |
Remove the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose.
Remove the 3 bolts and transmission oil cooler from the front engine mounting bracket.
12311A
10.REMOVE FRONT ENGINE MOUNTING BRACKET
| *A | w/ ATF Warmer |
| *B | w/o ATF Warmer |
Remove the 3 bolts and front engine mounting bracket from the automatic transaxle assembly.
35123A
11.REMOVE TRANSMISSION BREATHER SKIRT (w/o ATF Warmer)
Disconnect the breather plug hose from the transmission breather skirt.
Remove the bolt and transmission breather skirt from the transaxle.
Remove the clamp from the transmission breather skirt.
33823
12.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.
13.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the 4 bolts and 4 wire harness clamp brackets from the automatic transaxle assembly.
35150
14.REMOVE TRANSMISSION CASE PLUG ASSEMBLY
Remove the transmission case plug assembly from the automatic transaxle assembly.
Remove the O-ring from the transmission case plug assembly.
15.REMOVE TORQUE CONVERTER ASSEMBLY
Remove the torque converter assembly from the automatic transaxle assembly.