Home › Drivetrain › CLUTCH › CLUTCH UNIT › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014583 CLUTCH _0073994 CLUTCH UNIT A

CLUTCH  CLUTCH UNIT  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust from the moving section could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.


PROCEDURE

Hide 2.REMOVE CLUTCH LINE

a.
C287091

Using a (10 mm) union nut wrench, disconnect the clutch line.


b.

Remove the bolt and clutch line.


Hide 31407B 3.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

C204655

a.

Using a (10 mm) union nut wrench, separate the clutch release bleeder sub-assembly from the clutch release cylinder to bleeder tube.


b.

Remove the 2 bolts and clutch release bleeder sub-assembly from the manual transaxle case.


Hide 4.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

a.
C199330

Remove the clutch tube boot from the front transaxle case.


b.
C187781

Remove the 3 bolts and clutch release with bearing cylinder assembly and clutch release cylinder to bleeder tube.


Hide 31483 5.REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE

a.
C187782

Using a (10 mm) union nut wrench, remove the clutch release cylinder to bleeder tube from the clutch release with bearing cylinder assembly.


Hide 31210 6.REMOVE CLUTCH COVER ASSEMBLY

a.
C204659
1.156,1.365 0.958,1.844 0.958,1.844 1.24,1.354 false 0.854,1.844 1.115,2.104 0.26,0.26 10 false *a
*a Matchmark


Align the matchmark on the clutch cover assembly with the one on the flywheel sub-assembly.


b.

Loosen each set bolt one turn at a time until the spring tension is released.


c.

Remove the 6 set bolts and pull off the clutch cover assembly.

NOTICE:

Do not drop the clutch disc assembly.



Hide 31250 7.REMOVE CLUTCH DISC ASSEMBLY