Home › Drivetrain › EB62 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014584 EB62 MANUAL TRANSMISSION / TRANSAXLE _0074006 DIFFERENTIAL CASE A

EB62 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  DISASSEMBLY  


PROCEDURE

Hide 41221 1.REMOVE FRONT DIFFERENTIAL RING GEAR

a.
C199116
0.99,0.219 1.198,0.219 1.198,0.219 1.99,0.531 false 1.521,0.354 1.917,0.677 false 0.76,0.146 1.073,0.438 0.313,0.292 10 false *1
*1 Matchmark


Place matchmarks on the front differential ring gear and the front differential case.


b.
C199117

Remove the 12 bolts.


c.

Using a plastic-faced hammer, remove the front differential ring gear from the front differential case.


Hide 2.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

Hide 41342A 3.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

a.
C199118
0.885,1.552 1.052,1.552 1.052,1.552 1.115,1.115 false 0.521,1.479 1.021,1.802 0.5,0.323 10 false SST

Using SST and hammer, loosen the staked part of the front differential case.

SST
09930-00010  


b.
C199119

Using a (5 mm) pin punch and hammer, tap out the front differential pinion shaft straight pin from the front differential case.


Hide 41342F 4.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.
C200232

Remove the front No. 1 differential pinion shaft from the front differential case.


Hide 41331F 5.REMOVE FRONT DIFFERENTIAL SIDE GEAR

a.
C200233

Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front No. 1 differential side gear thrust washers and 2 front differential side gears from the front differential case.

HINT:

While rotating the front differential side gears, remove the 2 front differential pinions and 2 front differential pinion thrust washers.