Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
43502H
2.REMOVE FRONT AXLE SHAFT NUT
89543
3.SEPARATE FRONT SPEED SENSOR
Remove the bolt, disengage the clamp and separate the front speed sensor and front flexible hose.
Be sure to separate the front speed sensor from the front shock absorber assembly completely.
Remove the bolt and front speed sensor from the steering knuckle.
Prevent foreign matter from contacting the sensor tip.
Be careful not to damage the front speed sensor.
Clean the speed sensor installation hole and the contact surfaces every time the speed sensor is removed.
4.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
5.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
45470
6.SEPARATE TIE ROD ASSEMBLY
43420
7.SEPARATE FRONT DRIVE SHAFT ASSEMBLY
| *a | Matchmark |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
If it is difficult to separate, tap the end of the front drive shaft assembly using a brass bar and a hammer.
48069
8.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Remove the bolt and 2 nuts, and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.
9.REMOVE FRONT AXLE ASSEMBLY
Remove the 2 bolts, 2 nuts and front axle assembly from the front shock absorber assembly.
When removing the nuts, keep the bolts from rotating.
Be careful not to damage the drive shaft boot or speed sensor rotor.
43246B
10.REMOVE FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR
| *1 | Vinyl Tape |
Using a screwdriver with its tip wrapped with vinyl tape, remove the front No. 1 wheel bearing dust deflector.
Be careful not to damage the steering knuckle.
43502G
11.REMOVE FRONT AXLE HUB HOLE SNAP RING
Using snap ring pliers, remove the front axle hub hole snap ring.
43502C
12.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
Hold the front axle assembly between aluminum plates in a vise.
Do not overtighten the vise.
Using SST, remove the front axle hub sub-assembly.
Using SST and a press, remove the bearing inner race (outside) from the front axle hub sub-assembly.
Be careful not to drop the front axle hub sub-assembly.
47782
13.REMOVE FRONT DISC BRAKE DUST COVER
Remove the 4 bolts and front disc brake dust cover from the steering knuckle.
43502E
14.REMOVE FRONT AXLE HUB BEARING
| *1 | Steel Plate |
| *2 | V-block |
Place the bearing inner race (outside) on the front axle hub bearing.
Using SST, a steel plate, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.
Keep the steering knuckle level.