Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT AXLE ASSEMBLY
43340A
2.REMOVE FRONT LOWER BALL JOINT ASSEMBLY
43246B
3.REMOVE FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR
43502G
4.REMOVE FRONT AXLE HUB HOLE SNAP RING
43502C
5.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
47782
6.REMOVE FRONT DISC BRAKE DUST COVER
43212
7.REMOVE STEERING KNUCKLE
| *1 | Steel Plate |
| *2 | V-block |
Place the bearing inner race (outside) on the front axle hub bearing.
Using SST, a steel plate, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.
Keep the steering knuckle level.