1.REMOVE REAR WHEELS
17420
2.REMOVE CENTER EXHAUST PIPE ASSEMBLY
48840A
3.SEPARATE REAR STABILIZER LINK ASSEMBLY LH
Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.
48830D
4.SEPARATE REAR STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48812
5.REMOVE REAR STABILIZER BAR
17573A
6.REMOVE NO. 3 EXHAUST PIPE SUPPORT BRACKET
Remove the 2 bolts and No. 3 exhaust pipe support bracket from the rear suspension member sub-assembly.
58339N
7.REMOVE JACK UP BRACKET (w/ Bracket)
Remove the 2 bolts and jack up bracket from the rear suspension member sub-assembly.
48740F
8.SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
48730F
9.SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
Perform the same procedure as for the LH side.
48720A
10.SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
48710A
11.SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
Perform the same procedure as for the LH side.
51206A
12.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
| *1 | Engine Lifter |
| *2 | Attachment |
|
Attachment Placement Location |
Support the rear suspension member sub-assembly with an engine lifter using 4 attachments or equivalent tools as shown in the illustration.
Make sure to secure the rear suspension member sub-assembly to prevent it from dropping.
Use the attachments to keep the rear suspension member sub-assembly level.
Remove the 2 bolts, 4 nuts, 2 rear suspension member lower stopper sub-assemblies and 2 rear suspension member lower stoppers.
Slowly lower the rear suspension member sub-assembly.
When lowering the rear suspension member sub-assembly, be careful not to damage the vehicle body or other components installed on the vehicle.
w/ Member Cushion:
Remove the 2 differential support member cushions and 2 differential support member upper stoppers from the rear suspension member sub-assembly.
48740F
13.REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
48730F
14.REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
Perform the same procedure as for the LH side.
48720A
15.REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
48710A
16.REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
Perform the same procedure as for the LH side.
51249
17.REMOVE REAR SUSPENSION MEMBER DAMPER (w/ Dynamic Damper)
Remove the 2 bolts and rear suspension member damper from the rear suspension member sub-assembly.
52272A
18.REMOVE REAR SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION LH
Using SST and a press, remove the rear suspension member body mounting front cushion LH from the rear suspension member sub-assembly.
52271E
19.REMOVE REAR SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION RH
Perform the same procedure as the LH side.
52275A
20.REMOVE REAR SUSPENSION MEMBER BODY MOUNTING REAR CUSHION (for LH Side)
Using SST and a press, remove the rear suspension member body mounting rear cushion from the rear suspension member sub-assembly.
52275A
21.REMOVE REAR SUSPENSION MEMBER BODY MOUNTING REAR CUSHION (for RH Side)
Perform the same procedure as the LH side.
22.REMOVE HOLE PLUG
Remove the 2 hole plugs from the rear suspension member sub-assembly.