Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM19V0EQ _55 Steering _014596 POWER ASSIST SYSTEMS _0074061 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582/26  Assist Map Number Mismatch  


DESCRIPTION

When an incorrect ECM, an incorrect brake booster with master cylinder assembly or an incorrect main body ECU is installed after the assist map has been written the power steering ECU assembly, then DTC C1582/26 is stored because the data does not match the vehicle specifications.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1582/26 Assist Map Number Mismatch Assist map number mismatch
·

CAN communication system

·

Incorrect ECM

·

Incorrect brake actuator assembly (skid control ECU)

·

Incorrect main body ECU (multiplex network body ECU)

·

Power Steering ECU assembly


EPS Warning Light: Does not come on Assist map written

INSPECTION PROCEDURE

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Result Proceed to
DTC is not output. OK
DTC is output. NG



OK

2.CHECK RELATED PART (ECM, MAIN BODY ECU AND SKID CONTROL ECU)

NG

2.CHECK RELATED PART (ECM, MAIN BODY ECU AND SKID CONTROL ECU)
a.

Check if any of the parts listed below have been replaced with an incorrect part in the past.

Related Part ECM
Main body ECU (multiplex network body ECU)
Brake actuator assembly (skid control ECU)

NOTICE:
When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
·

Refer to the following procedures to remove the ECM.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>ECM>REMOVAL

·

Refer to the following procedures to remove the main body ECU (multiplex network body ECU).

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL

·

Refer to the following procedures to remove the brake actuator assembly (skid control ECU).

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL



HINT:
·

DTC C1582/26 is stored when a part with an incorrect part number is installed for the related parts listed above.

·

When DTC C1582/26 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.




Result:
Result Proceed to
All installed related parts have correct part number A
Part with incorrect part number is installed B



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER