Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch to ON.
Do not rotate the spiral cable sub-assembly without the steering wheel with the battery connected and the ignition switch to ON.
Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch to ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch to ON.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
45100
3.REMOVE STEERING WHEEL ASSEMBLY
| *a | Matchmark |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.
| *a | Turn |
| *b | Hold |
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
45107
4.REMOVE HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch)
Disconnect the connector and remove the horn button wire sub-assembly.
45116
5.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
| *1 | Pin |
| *2 | Guide |
Remove the 2 screws.
Disengage the 2 claws, 2 pins and 2 guides to remove the No. 1 steering wheel ornament.
84250A
6.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
84610F
7.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
84523
8.REMOVE NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
84632
9.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
84633
10.REMOVE CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)
Remove the cruise control switch wire.
45713A
11.REMOVE STEERING SHAKE DAMPER
Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.