Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2011.10–2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014599 AUDIO / VIDEO _0074081 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

The radio and display receiver assembly and roof console box assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Telephone microphone signal is lost.
·

Roof console box assembly

·

Telephone microphone assembly

·

Radio and display receiver assembly

·

Harness or connector



WIRING DIAGRAM

E226160E16
0.588,2.016 2.786,2.392 2.198,0.376 10 Roof Console Box Assembly (Telephone Microphone Assembly) 4.408,1.836 4.759,1.983 0.351,0.147 10 I155 4.408,2.025 6.786,2.193 2.378,0.168 10 Radio and Display Receiver Assembly 5.113,1.453 5.492,1.6 0.379,0.147 10 MIN- 5.113,0.655 5.533,0.829 0.42,0.175 10 SNS2 4.83,1.36 5.012,1.507 0.181,0.147 10 19 4.894,0.561 4.999,0.736 0.105,0.175 10 6 1.669,1.458 2.11,1.605 0.44,0.147 10 MCO- 1.67,0.652 2.082,0.827 0.412,0.175 10 SNS2 2.157,1.355 2.336,1.502 0.179,0.147 10 12 2.157,0.556 2.355,0.731 0.198,0.175 10 15 0.588,1.836 0.938,1.983 0.351,0.147 10 S7

PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
E176671C35
1.479,0.542 1.969,0.833 0.49,0.292 2.094,2 2.604,2.667 false 1.604,0.604 2.219,0.948 0.615,0.344 10 false I155 0.208,0.146 0.594,0.458 0.385,0.313 10 false *a 2.531,2.719 3.115,3.083 0.583,0.365 10 false MIN-
*a Component with harness connected
(Radio and Display Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I155-19 (MIN-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
a.

Disconnect the radio and display receiver assembly connector.


b.

Disconnect the roof console box assembly (telephone microphone assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I155-6 (SNS2) - S7-15 (SNS2) Always Below 1 Ω
I155-19 (MIN-) - S7-12 (MCO-) Always Below 1 Ω
I155-6 (SNS2) - Body ground Always 10 kΩ or higher
I155-19 (MIN-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)
a.
E187117C26
1.469,0.229 1.958,0.521 0.49,0.292 1.74,1.406 1.365,1.677 false 2.135,1.406 2.51,1.677 false 1.646,0.292 2.042,0.542 0.396,0.25 10 false S7 0.156,0.063 0.354,0.26 0.198,0.198 10 false *a 1.135,1.719 1.885,2.073 0.75,0.354 10 false SNS2 2.375,1.708 3.063,2.021 0.688,0.313 10 false MCO-
*a Component without harness connected
(Roof Console Box Assembly (Telephone Microphone Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
S7-15 (SNS2) - S7-12 (MCO-) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

4.REPLACE TELEPHONE MICROPHONE ASSEMBLY
4.REPLACE TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)