Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the switch signals using the AVC-LAN.
If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.
The navigation ECU sub-assembly is the master unit.
| *a | Component without harness connected
(Navigation ECU Sub-assembly) |
Disconnect the navigation ECU sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I67-7 (TX1+) - I67-8 (TX1-) | Always | 60 to 80 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER(for HDD)>REMOVAL
Disconnect the navigation ECU sub-assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I69-8 (TX+) - I67-7 (TX1+) | Always | Below 1 Ω |
| I69-7 (TX-) - I67-8 (TX1-) | Always | Below 1 Ω |
| I69-8 (TX+) - Body ground | Always | 10 kΩ or higher |
| I69-7 (TX-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.
Check all slave units.
If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.
Master unit returns to normal operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER(for HDD)>REMOVAL