Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER(for HDD) › 2011.10–2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014600 NAVIGATION / MULTI INFO DISPLAY _0074085 NAVIGATION RECEIVER(for HDD) A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER(for HDD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken when handling the navigation receiver assembly.

·

When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 58804A 5.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55660 7.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 8.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

a.
E226808C01
2.729,0.813 3.083,0.813 false 3.115,0.729 3.271,0.875 0.156,0.146 10 *1
*1 Protective Tape


Apply protective tape to the area shown in the illustration.


b.
E223757

Remove the 4 bolts.


c.
E226770

Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.


d.

Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.


Hide 86211J 9.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.
E223738

Remove the 5 screws and No. 1 radio receiver bracket.


Hide 86212C 10.REMOVE NO. 2 RADIO RECEIVER BRACKET

a.
E230755

Remove the 5 screws and No. 2 radio receiver bracket.


Hide 13.REMOVE NAVIGATION ECU SUB-ASSEMBLY