This DTC is stored when the hard disk drive which is built into the navigation ECU sub-assembly has an initialization malfunction or read/write errors occur more than a specified number of times.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15B8 | Harddisk Malfunction | Hard Disk Drive (HDD) malfunction | Hard disk drive |
Enter the "HDD Check" screen. Refer to Check Hard Disk Drive in Operation Check.
Select "HDD Check" and check the result.
"OK" is displayed.
After "HDD Check" is selected, it may take a while until the result is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
The hard disk drive may be malfunctioning even if DTC B15B8 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG