Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › HARD DISK DRIVE › 2011.10–2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014600 NAVIGATION / MULTI INFO DISPLAY _0074084 HARD DISK DRIVE A

NAVIGATION / MULTI INFO DISPLAY  HARD DISK DRIVE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the navigation receiver assembly.

·

When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 58804A 5.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55660 7.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 8.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

Hide 10.REMOVE HARD DISK DRIVE

a.
E223753

Remove the 2 screws.


b.

Disengage the 2 guides to remove the cover.


c.
E223754

Pull out the hard disk drive from the navigation receiver assembly in the direction shown by the arrow in the illustration to remove it.