Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0074091 CLEARANCE SONAR MAIN SWITCH A

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION (for RHD)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62312B 3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 55318C 4.REMOVE INSTRUMENT SIDE PANEL

Hide 55474C 5.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for LHD)

Hide 55431B 6.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 55650 7.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55410C 8.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 84490A 9.REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.
E233574

Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.