Home › Power Source / Network › 2AR-FE BATTERY / CHARGING › CHARGING SYSTEM
RM19V0EQ _57 Power Source / Network _014602 2AR-FE BATTERY / CHARGING _0074098 CHARGING SYSTEM J

2AR-FE BATTERY / CHARGING  CHARGING SYSTEM  Charge Warning Light Comes ON while Driving  


INSPECTION PROCEDURE

PROCEDURE

1.CHECK LOCK FUNCTION OF GENERATOR PULLEY WITH CLUTCH
a.

Check the lock function with the pulley installed in the vehicle.

i.

Visually check that the rotor in the generator operates with the engine started.



b.

Check the lock function with the pulley removed from the vehicle.

i.

Remove the generator pulley cap.


ii.
A192786C01
2.375,0.917 2.542,1.094 0.167,0.177 10 *b 0.917,0.917 1.094,1.094 0.177,0.177 10 *a
*a Free
*b Lock


Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

Click herePower Source / Network>2AR-FE BATTERY / CHARGING>GENERATOR>INSPECTION

OK:

The outer ring locks.




Result:
Result
OK
NG



OK

2.CHECK LOCK OF GENERATOR PULLEY WITH CLUTCH

NG

REPLACE GENERATOR PULLEY WITH CLUTCH

2.CHECK LOCK OF GENERATOR PULLEY WITH CLUTCH
a.

Start the engine and visually check for looseness of the generator pulley with clutch.

OK:

The generator pulley with clutch is not loose.



Result:
Result
OK
NG



OK

NG

TIGHTEN GENERATOR PULLEY WITH CLUTCH TO THE SPECIFIED TORQUE