These DTCs are stored when there is a CAN communication error between the certification ECU (smart key ECU assembly) and the ECM, main body ECU (multiplex network body ECU) or combination meter assembly.
When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM | CAN communication error between the certification ECU (smart key ECU assembly) and ECM (1-trip detection*) | ECM | DTC Output Confirmation Operation
Turn the engine switch on (IG) and wait 10 seconds or more. |
| U0140 | Lost Communication with Main Body ECU | CAN communication error between the certification ECU (smart key ECU assembly) and main body ECU (1-trip detection*) | Main body ECU (multiplex network body ECU) | DTC Output Confirmation Operation
Always |
| U0155 | Lost Communication with Combination Meter | CAN communication error between the certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection*) | Combination meter assembly | DTC Output Confirmation Operation
Turn the engine switch on (IG) and wait 10 seconds or more. |
*: Only detected while a malfunction is present and the engine switch is on (IG)
| DTC Code | Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|---|
| U0100 | There is no effect on vehicle behavior. | If the following conditions are met, it is determined that the malfunction is not in the direct line (NE) but in CAN communication.
·
When the engine switch is pressed, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking. ·
When the engine switch is pressed and held, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking. If the following conditions are met, it is determined that there is a malfunction in both CAN communication and the direct line (NE). ·
When the engine switch is pressed, the engine stops cranking after 6 seconds. ·
When the engine switch is pressed and held, the engine remains cranking for up to 30 seconds. |
| U0140 | Doors cannot be locked or unlocked. The warning (wireless buzzer) does not sound. | - |
| U0155 | The warning (meter buzzer) does not sound and the meter does not indicate a warning. | - |
| DTC | Data List Item | Active Test Item |
|---|---|---|
| U0100
U0140 U0155 |
- | - |
When using the intelligent tester with the engine switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle, select the vehicle type under manual mode, and then enter the following menus: Body / Entry&Start / DTC.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Note any DTCs that are output.
| Proceed to |
|---|
| NEXT |
NEXT
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING