When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (multiplex network body ECU) transmits a signal to cause the horn to sound at intervals of 0.4 seconds.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Press the horn switch and check if the horns sound.
| Result | Proceed to |
|---|---|
| Horns sound | A |
| Horns do not sound | B |
A
B
Remove the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3D-15 - MB-28 (HORN) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG