This DTC is stored when one of the following occurs: 1) the ECM detects errors in its own communication with the transponder key ECU assembly; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU assembly and ECM is different and an engine start is attempted.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2799 | One of the following conditions is met:
·
Error in communication between ECM and transponder key ECU assembly. ·
Error in communication lines. ·
Communication ID is different during communication with transponder key ECU assembly. |
·
Wire harness or connector ·
ECM ·
Transponder key ECU assembly |
If the transponder key ECU assembly or ECM is replaced, refer to Service Bulletin.
If the transponder key ECU assembly DTC is output simultaneously, troubleshoot the transponder key ECU assembly DTCs first.
Clear the DTCs.
Recheck for DTCs.
DTC B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Re-register the ECU communication ID.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Recheck for DTCs.
DTC B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Check that the connectors are properly connected to the ECM and transponder key ECU assembly.
Connectors are properly connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the transponder key ECU assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I19-12 (EFII) - A25-29 (IMO) | Always | Below 1 Ω |
| I19-13 (EFIO) - A25-28 (IMI) | Always | Below 1 Ω |
| I19-12 (EFII) - Body ground | Always | 10 kΩ or higher |
| I19-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
| A25-29 (IMO) - Body ground | Always | 10 kΩ or higher |
| A25-28 (IMI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the ECM.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Register the ECU communication ID.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Recheck for DTCs.
DTC B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG