Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY
RM19V0EQ _58 Vehicle Interior _014610 SUPPLEMENTAL RESTRAINT SYSTEMS _0074151 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 73900 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B296279C01
1.771,2.24 1.698,2.24 1.698,2.24 1.5,2.448 true 1.76,0.865 1.063,0.865 true 0.885,0.781 1.083,0.979 0.198,0.198 10 false *1 1.802,2.167 2.01,2.385 0.208,0.219 10 false *2
*1 Airbag Connector
*2 Airbag Connector Lock


Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the lock to install the airbag connector.


e.

Temporarily install the lower No. 1 instrument panel airbag assembly with the 2 hooks.


f.

Engage the 2 claws to install the DLC3.


g.

Install the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



Hide 55432D 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 53601 3.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

HINT:

Perform the same procedure as the driver side of LHD vehicles.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION


Hide 55317A 4.INSTALL INSTRUMENT SIDE PANEL RH

HINT:

Perform the same procedure as the driver side of LHD vehicles.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION


Hide 62311B 5.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 62111A 6.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Perform the same procedure as the driver side of LHD vehicles.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 67913 7.INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Perform the same procedure as the driver side of LHD vehicles.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION