Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2011.10–2016.05
RM19V0EQ _58 Vehicle Interior _014610 SUPPLEMENTAL RESTRAINT SYSTEMS _0074152 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

w/o VSC: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o VSC)>PRECAUTION

w/ VSC: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 55011A 2.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 82142A 3.DISCONNECT NO. 2 INSTRUMENT PANEL WIRE

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B288991C04
0.688,2.729 0.688,2.99 0.688,2.99 2.146,2.99 false 1.844,2.74 1.844,2.99 false 2.188,2.896 2.438,3.135 0.25,0.24 10 false *a
*a Slider


Slide the slider to release the lock, and then disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 4.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Hide 73960A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B296281

Remove the 2 screws.


b.
B296282

Lean the instrument panel safety pad assembly and disengage the 3 hooks.


c.
B296283

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad assembly.


Hide 82142A 6.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B296284C01
2.594,2.24 2.49,2.135 2.49,2.135 2.281,2.135 false 1.771,0.646 1.5,0.365 1.5,0.365 1.354,0.365 false 1.969,0.74 2.229,0.448 2.229,0.448 2.698,0.448 false 2.729,0.365 2.969,0.594 0.24,0.229 10 false *1 1.198,0.292 1.427,0.5 0.229,0.208 10 false *2 2.135,2.063 2.302,2.24 0.167,0.177 10 false *3
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock


Disengage the clamp.


b.

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.


c.

Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.