Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY
RM19V0EQ _58 Vehicle Interior _014610 SUPPLEMENTAL RESTRAINT SYSTEMS _0074158 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC)>PRECAUTION

·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage .

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>DISASSEMBLY

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>DISASSEMBLY



HINT:

Use the same procedure for the LH side and RH side.


PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Hide 2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Hide 3.DISCONNECT AIRBAG WIRE HARNESS (for Manual Seat)

a.
B270252

Disconnect the rubber band of the separate type front seatback cover with pad.


b.
B280208

Disengage the fastener to separate the airbag wire harness.


Hide 4.DISCONNECT AIRBAG WIRE HARNESS (for Power Seat)

a.
B281093

Disconnect the rubber band of the separate type front seatback cover with pad.


b.
B281104

Disengage the fastener to separate the airbag wire harness.


Hide 5.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)

Hide 6.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)

Hide 73920A 7.REMOVE FRONT SEAT AIRBAG ASSEMBLY

a.

for Manual Seat:

i.
B281498

Disengage the claw and 3 clamps to disconnect the airbag wire harness.



b.

for Power Seat:

i.
B281105

Disengage the claw and 3 clamps to disconnect the airbag wire harness.



c.
B278812

Disengage the 2 clamps.


d.

Remove the 2 nuts and the front seat airbag assembly.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.