Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat)
RM19V0EQ _58 Vehicle Interior _014611 SEAT _0074162 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect each connector and clamp under the seat.


c.

Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



d.

Temporarily install the front seat assembly with the 4 bolts.


e.

Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.


f.
B281471N03
0.396,1.573 0.646,1.792 0.25,0.219 10 true (1) 0.865,1.854 1.094,2.073 0.229,0.219 10 true (2)

Tighten the 2 bolts on the front side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

Tighten the bolts in the order indicated in the illustration.



g.

Operate the slide and vertical power seat switch knob and move the seat to the foremost position.


h.
B281472N04
1.376,1.754 1.579,1.933 0.203,0.179 10 (2) 1.941,1.754 2.143,1.933 0.203,0.179 10 (1)

Tighten the 2 bolts on the rear side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

Tighten the bolts in the order indicated in the illustration.



Hide 72158 2.INSTALL REAR INNER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the rear inner seat track bracket cover.


Hide 72138J 3.INSTALL REAR OUTER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the rear outer seat track bracket cover.


Hide 71910A 4.INSTALL FRONT SEAT HEADREST ASSEMBLY