73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Engage the guide.
Install the bolt <A> first, then the bolt <B> to temporarily install the front shoulder belt anchor adjuster assembly.
Fully tighten the 2 bolts.
73220
2.INSPECT FRONT SEAT OUTER BELT ASSEMBLY
73220
3.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Install the bolt <A> first, then the bolt <B> to temporarily install the front seat outer belt assembly.
Fully tighten the 2 bolts.
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
62412B
4.INSTALL CENTER PILLAR UPPER GARNISH
62414A
5.INSTALL CENTER PILLAR LOWER GARNISH
73220
6.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Install the floor anchor of the front seat outer belt assembly with the bolt.
Check if the ELR locks.
The check should be performed with the front seat outer belt assembly installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
73233
7.INSTALL LAP BELT OUTER ANCHOR COVER
Engage the 3 claws to install the lap belt outer anchor cover.
62332A
8.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
for LH Side: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
for RH Side: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67918A
9.INSTALL REAR DOOR SCUFF PLATE
62312B
10.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
for LH Side: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
for RH Side: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67914
11.INSTALL FRONT DOOR SCUFF PLATE
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
13.INSPECT SRS WARNING LIGHT