1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67914
3.REMOVE FRONT DOOR SCUFF PLATE
62312B
4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip.
67918A
5.REMOVE REAR DOOR SCUFF PLATE
62332A
6.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
73233
7.REMOVE LAP BELT OUTER ANCHOR COVER
Disengage the 3 claws and remove the lap belt outer anchor cover.
73220
8.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.
62414A
9.REMOVE CENTER PILLAR LOWER GARNISH
62412B
10.REMOVE CENTER PILLAR UPPER GARNISH
73220
11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
| *1 | Protective Tape |
Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
Tape the screwdriver tip before use.
Remove the 2 bolts and front seat outer belt assembly.
73200A
12.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts.
Disengage the guide and remove the front shoulder belt anchor adjuster assembly.