Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM19V0EQ _58 Vehicle Interior _014613 HEATING / AIR CONDITIONING _0074197 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1411/11  Room Temperature Sensor Circuit  


DESCRIPTION

The room temperature sensor (cooler thermistor) is installed in the instrument panel to detect the cabin temperature which is used to control the heater and air conditioning system AUTO mode. The resistance of the room temperature sensor (cooler thermistor) changes in accordance with the cabin temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies a voltage (5 V) to the room temperature sensor (cooler thermistor) and reads voltage changes due to changes in the resistance of the room temperature sensor (cooler thermistor).

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1411/11 Room Temperature Sensor Circuit Open or short in room temperature sensor (cooler thermistor) circuit
·

Room temperature sensor (cooler thermistor)

·

Harness or connector between room temperature sensor (cooler thermistor) and air conditioning amplifier assembly

·

Air conditioning amplifier assembly


Memorized
(4 sec. or more)*1

*1: The air conditioning amplifier assembly stores the DTC of the respective malfunction if it has occurred for the period of time indicated in the brackets.


HINT:

If the cabin temperature is approx. -18.6°C (-1.48°F) or lower, DTC B1411/11 may be output even though the system is normal.


WIRING DIAGRAM

E236721
2.147,0.468 2.245,0.643 0.098,0.175 10 1 2.147,1.419 2.245,1.594 0.098,0.175 10 2 1.963,0.468 2.076,0.643 0.113,0.175 10 + 1.994,1.419 2.076,1.594 0.082,0.175 10 - 5.117,0.472 5.291,0.647 0.174,0.175 10 29 5.119,1.425 5.291,1.6 0.172,0.175 10 34 5.419,0.56 5.622,0.734 0.203,0.175 10 TR 5.419,1.512 5.762,1.687 0.343,0.175 10 SG-1 0.833,1.802 1.154,1.977 0.321,0.175 10 I57 0.833,1.961 2.529,2.293 1.697,0.332 10 Room Temperature Sensor (Cooler Thermistor) 5.067,1.883 5.352,2.057 0.285,0.175 10 I77 5.067,2.041 6.75,2.355 1.683,0.314 10 Air Conditioning Amplifier Assembly

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Air Conditioner / Data List.


e.

Check the value(s) by referring to the table below.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Room Temperature Sensor Room temperature sensor (cooler thermistor) min.: -6.50°C (20.30°F)
max.: 57.25°C (135.05°F)
Actual cabin temperature displayed -
Body Electrical > Air Conditioner > Data List
Tester Display
Room Temperature Sensor
50003 121 1
OK:

The display is as specified in the normal condition column.



Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C



A

2.INSPECT ROOM TEMPERATURE SENSOR (COOLER THERMISTOR)

B

C

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

2.INSPECT ROOM TEMPERATURE SENSOR (COOLER THERMISTOR)
a.
E202806
0.875,0.167 1.219,0.385 0.344,0.219 1.969,2.771 1.594,3.052 false 1.677,0.469 1.125,0.688 false 2.563,1.406 1.781,1.104 false 2.406,0.719 1.854,0.469 false 2.417,0.74 2.594,0.969 0.177,0.229 10 false + 2.646,1.344 2.958,1.542 0.313,0.198 10 false *b 2.042,2.583 2.354,2.781 0.313,0.198 10 false *e 0.146,2.833 0.458,3.031 0.313,0.198 10 false *c 1.844,4.198 2.073,4.385 0.229,0.188 10 false *d 0.938,0.188 1.26,0.417 0.323,0.229 10 false I57 1.042,0.708 1.156,0.917 0.115,0.208 10 false - 0.188,0.135 0.5,0.333 0.313,0.198 10 false *a
*a Component without harness connected
(Room Temperature Sensor (Cooler Thermistor))
*b Sensing Portion
*c Resistance (kΩ)
*d Temperature (°C (°F))
*e Allowable Range


Remove the room temperature sensor (cooler thermistor).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>ROOM TEMPERATURE SENSOR>REMOVAL


b.

Disconnect the I57 room temperature sensor (cooler thermistor) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I57-1 (+) - I57-2 (-) 10°C (50°F) 3.00 to 3.73 kΩ
I57-1 (+) - I57-2 (-) 15°C (59°F) 2.45 to 2.88 kΩ
I57-1 (+) - I57-2 (-) 20°C (68°F) 1.95 to 2.30 kΩ
I57-1 (+) - I57-2 (-) 25°C (77°F) 1.60 to 1.80 kΩ
I57-1 (+) - I57-2 (-) 30°C (86°F) 1.28 to 1.47 kΩ
I57-1 (+) - I57-2 (-) 35°C (95°F) 1.00 to 1.22 kΩ
I57-1 (+) - I57-2 (-) 40°C (104°F) 0.80 to 1.00 kΩ
I57-1 (+) - I57-2 (-) 45°C (113°F) 0.65 to 0.85 kΩ
I57-1 (+) - I57-2 (-) 50°C (122°F) 0.50 to 0.70 kΩ
I57-1 (+) - I57-2 (-) 55°C (131°F) 0.44 to 0.60 kΩ
I57-1 (+) - I57-2 (-) 60°C (140°F) 0.36 to 0.50 kΩ


NOTICE:
·

Hold the sensor only by its connector. Touching the sensor may change the resistance value.

·

When measuring, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph).



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (ROOM TEMPERATURE SENSOR (COOLER THERMISTOR) - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPLACE ROOM TEMPERATURE SENSOR (COOLER THERMISTOR)

3.CHECK HARNESS AND CONNECTOR (ROOM TEMPERATURE SENSOR (COOLER THERMISTOR) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Disconnect the I77 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I77-29 (TR) - I57-1 (+) Always Below 1 Ω
I77-34 (SG-1) - I57-2 (-) Always Below 1 Ω
I77-29 (TR) - Body ground Always 10 kΩ or higher
I77-34 (SG-1) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR