Home › Vehicle Exterior › DOOR / HATCH › HOOD › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014618 DOOR / HATCH _0074220 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B277160C07
0.667,0.281 1.073,0.552 0.406,0.271 10 false *1 2.563,0.281 2.917,0.552 0.354,0.271 10 false *2
*1 Centering Bolt
*2 Standard Bolt


HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 1.INSPECT HOOD SUB-ASSEMBLY

Hide 2.ADJUST HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

i.
B277161

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fender by moving the hood.


iii.

Tighten the 4 hinge bolts after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood using the cushion rubbers.

i.
B291324

Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 cushion rubbers.




c.

Remove the radiator grille sub-assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE>REMOVAL


d.

Adjust the hood lock.

i.
B293476C01
2.75,1.406 3.135,1.5 false 2.615,1.313 2.948,1.542 0.333,0.229 10 false *1
*1 Protective Tape


Using a screwdriver, remove the hood lock nut cap.

HINT:

Tape the screwdriver tip before use.



ii.
B293474C01
1.708,1.552 1.229,1.844 false 1.073,1.802 1.24,1.958 0.167,0.156 10 false *1
*1 Hood Lock Bolt


Loosen the 2 bolts and hood lock bolt.


iii.

Adjust the hood lock and tighten the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


iv.

Check that the striker can engage with the hood lock smoothly.



e.
B293475

Install a new hood lock nut cap.


f.

Install the radiator grille sub-assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE>INSTALLATION