Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014621 LIGHTING (EXT) _0074247 AUTOMATIC HIGH BEAM SYSTEM J

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  AFS ECU Power Source Circuit  


DESCRIPTION

This circuit detects the state of the ignition switch, and sends it to the AFS ECU (headlight swivel ECU assembly).

WIRING DIAGRAM

E223770E10
5.094,2.75 6.792,3.146 1.698,0.396 10 false AFS ECU (Headlight Swivel ECU Assembly) 5.094,2.583 5.375,2.771 0.281,0.188 10 false A35 0.615,1.104 1.979,1.292 1.365,0.188 10 false from IG1 NO. 1 Relay 5.448,1.094 5.646,1.292 0.198,0.198 10 false IG 5.448,2.188 5.646,2.385 0.198,0.198 10 false E1 5.188,2.073 5.375,2.219 0.188,0.146 10 false 22 5.188,0.979 5.365,1.156 0.177,0.177 10 false 15 3.51,1.24 4.135,1.438 0.625,0.198 10 false H-LP LVL

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BATTERY - AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY))
a.
E166980C06
1.531,1.417 2.01,1.656 0.479,0.24 0.552,2.396 0.552,2.802 false 0.135,0.115 0.323,0.292 0.188,0.177 10 false *a 1.646,1.458 2.031,1.698 0.385,0.24 10 false A35 0.458,2.844 0.719,3.073 0.26,0.229 10 false IG
*a Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly))


Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A35-15 (IG) - Body ground Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A35-22 (E1) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR