Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014621 LIGHTING (EXT) _0074247 AUTOMATIC HIGH BEAM SYSTEM T

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  PROBLEM SYMPTOMS TABLE  


Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Automatic High Beam System
Symptom Suspected Area Link
Inner rear view mirror assembly indicator light does not come on when ignition switch is turned from off to ON. Inner rear view mirror assembly Click here
Harness or connector -
Inner rear view mirror assembly indicator light remains on or flashes when inner rear view mirror assembly AUTO switch is pressed. Inner rear view mirror assembly Click here
Automatic high beam indicator light (green) does not come on when automatic high beam system is in standby mode (automatic light control system operates normally). Combination meter assembly Click here
Main body ECU (multiplex network body ECU) Click here
Automatic high beam indicator light (green) does not come on when automatic high beam system is in standby mode (automatic light control system does not operate). Check DTCs Click here
AFS ECU power source circuit Click here
High beam headlight circuit Click here
Headlight dimmer switch circuit Click here
Check automatic light control system operation Click here
Check Data List (Auto H Beam STS) Click here
Inner rear view mirror assembly Click here
AFS ECU (headlight swivel ECU assembly) Click here
Main body ECU (multiplex network body ECU) Click here
Automatic high beam indicator light (yellow) comes on. Check DTCs Click here
Main body ECU (multiplex network body ECU) Click here
Combination meter assembly Click here

HINT:
·

Camera detection malfunctions can be detected using the intelligent tester. Under the following conditions, if the camera built into the inner rear view mirror assembly cannot detect other vehicles or lights correctly, it will stop automatic high beam control and turn off the automatic high beam indicator light:

·

When the front windshield is not clear (ice, snow or frost on the glass).

·

When the front windshield is dirty (sand, mud, water stains or bugs are on the glass).


·

Aiming misalignment of the camera can be detected using the intelligent tester. If the camera aiming is misaligned, check the following conditions:

·

Check if the vehicle is inclined.

·

Check if the windshield glass is installed correctly.

·

Check if the inner rear view mirror assembly is installed correctly.

·

Check if there is deformation of the camera or stay of the inner rear view mirror assembly.