The DTC is stored when the main body ECU (multiplex network body ECU) detects malfunctions in the automatic high beam system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system | ·
Steering angle sensor (spiral cable sub-assembly) ·
Vehicle stability control system ·
CAN communication system ·
Inner rear view mirror assembly ·
AFS ECU (headlight swivel ECU assembly) |
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
DTC B124B is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| Other DTC is not output | A |
| DTC B2414 is output | B |
| DTC B2415 is output | C |
| CAN communication system DTC is output | D |
A
B
C
D
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the inner rear view mirror assembly with a new or known good one.
Click hereVehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
DTC B124B is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG