Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074267 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Move the front bumper assembly into position and install the 3 clips.


b.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when pulling back the side of the front bumper assembly.


HINT:

Use the same procedure for the RH side and LH side.



c.
B298681

Engage the 3 claws to install the front bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.



d.

Install the 6 screws.


e.
B279839C04
2.01,2.781 1.833,2.781 false 2.948,1.448 3.198,1.698 0.25,0.25 10 *b 2.365,1.448 2.615,1.698 0.25,0.25 10 *a 2.042,2.677 2.385,2.958 0.344,0.281 10 *1
*1 Pin Hold Clip
*a Correct
*b Incorrect


Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for the RH side and LH side.



f.

Install the clip.

HINT:

Use the same procedure for the RH side and LH side.



Hide 2.INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Hide 3.ADJUST FOG LIGHT ASSEMBLY (for Sport Package)