Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074272 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 75720 2.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY

a.
B280068

Engage the 6 claws to install the front door belt moulding assembly.


Hide 68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 4.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 87940 5.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 7.INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side)