1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
67832
4.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
5.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68151C
6.REMOVE FRONT DOOR GLASS RUN
68620
7.REMOVE FRONT DOOR CHECK ASSEMBLY
67862
8.REMOVE FRONT DOOR WEATHERSTRIP
67664C
9.REMOVE DOOR FRAME GARNISH
75986B
10.REMOVE FRONT DOOR STRIPE
Using a heat light, heat the front door stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body and Front Door Outside Stripe | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the front door stripe to remove it.
When pulling on the stripe, pull it parallel to the body.
75976G
11.REMOVE FRONT DOOR LOWER OUTSIDE STRIPE
Using a heat light, heat the front door lower outside stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body and Front Door Rear Outside Stripe | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the front door lower outside stripe to remove it.
When pulling on the stripe, pull it parallel to the body.