This DTC is stored when the navigation ECU sub-assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1691 | Back Camera Initialization Incomplete | Back camera initial setting has not been memorized | ·
Rear television camera optical axis adjustment ·
Navigation ECU sub-assembly |
When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation ECU sub-assembly.
Rear television camera optical axis adjustment.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1691 is output | A |
| DTCs are not output | B |
If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.
If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the navigation ECU sub-assembly.
A
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER(for HDD)>REMOVAL
B