Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2011.10–2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0074096 REAR VIEW MONITOR SYSTEM J

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  Image from Camera for Rear View Monitor is Abnormal  


DESCRIPTION

The video signal of the rear television camera assembly is transmitted to the radio and display receiver assembly.

WIRING DIAGRAM

for RHD before Oct. 2014, for LHD
E267063E41
2.354,0.531 2.677,0.74 0.323,0.208 10 false 7 2.271,1.115 2.729,1.313 0.458,0.198 10 false I154 2.271,1.51 2.729,1.708 0.458,0.198 10 false I154 2.271,1.906 2.729,2.104 0.458,0.198 10 false I154 2.271,2.302 2.729,2.5 0.458,0.198 10 false I152 1.854,0.708 2.313,0.906 0.458,0.198 10 false CA+ 1.938,1.094 2.396,1.292 0.458,0.198 10 false V+ 1.948,1.5 2.406,1.698 0.458,0.198 10 false V- 1.729,1.896 2.25,2.115 0.521,0.219 10 false CGND 1.75,2.302 2.271,2.521 0.521,0.219 10 false GND1 2.354,0.927 2.677,1.135 0.323,0.208 10 false 8 2.313,1.323 2.635,1.531 0.323,0.208 10 false 16 2.313,1.719 2.635,1.927 0.323,0.208 10 false 15 2.26,0.719 2.719,0.917 0.458,0.198 10 false I154 0.802,2.615 2.5,3.052 1.698,0.438 10 false Radio and Display Receiver Assembly 2.354,2.115 2.677,2.323 0.323,0.208 10 false 7 4.844,0.625 5.167,0.833 0.323,0.208 10 false 6 4.844,1.021 5.167,1.229 0.323,0.208 10 false 3 4.844,1.417 5.146,1.635 0.302,0.219 10 false 2 4.844,1.813 5.167,2.021 0.323,0.208 10 false 5 5.021,0.708 5.479,0.906 0.458,0.198 10 false CB+ 5.021,1.115 5.479,1.313 0.458,0.198 10 false CV+ 5.031,1.51 5.5,1.75 0.469,0.24 10 false CV- 5.021,1.896 5.542,2.115 0.521,0.219 10 false CGND 4.833,2.219 5.292,2.417 0.458,0.198 10 false T6 4.833,2.385 6.333,2.917 1.5,0.531 10 false Rear Television Camera Assembly 3.115,3.188 4.948,3.385 1.833,0.198 10 false *: Shielded 3.552,1.75 3.865,1.948 0.313,0.198 10 false *

for RHD from Oct. 2014
E267063E40
2.313,0.51 2.635,0.719 0.323,0.208 10 false 11 2.271,1.104 2.729,1.302 0.458,0.198 10 false I206 2.271,1.5 2.729,1.698 0.458,0.198 10 false I206 2.271,1.896 2.729,2.094 0.458,0.198 10 false I206 2.271,2.292 2.729,2.49 0.458,0.198 10 false I152 1.854,0.708 2.313,0.906 0.458,0.198 10 false CA+ 1.938,1.094 2.396,1.292 0.458,0.198 10 false V+ 1.948,1.5 2.406,1.698 0.458,0.198 10 false V- 1.729,1.896 2.25,2.115 0.521,0.219 10 false CGND 1.75,2.292 2.271,2.51 0.521,0.219 10 false GND1 2.313,0.917 2.635,1.125 0.323,0.208 10 false 12 2.323,1.313 2.646,1.521 0.323,0.208 10 false 24 2.323,1.708 2.646,1.917 0.323,0.208 10 false 23 2.26,0.708 2.719,0.906 0.458,0.198 10 false I206 0.333,2.635 2.688,2.865 2.354,0.229 10 false Radio and Display Receiver Assembly 2.354,2.104 2.677,2.313 0.323,0.208 10 false 7 4.833,0.615 5.156,0.823 0.323,0.208 10 false 6 4.833,1.01 5.156,1.219 0.323,0.208 10 false 3 4.833,1.406 5.135,1.625 0.302,0.219 10 false 2 4.833,1.802 5.156,2.01 0.323,0.208 10 false 5 5.021,0.708 5.479,0.906 0.458,0.198 10 false CB+ 5.021,1.115 5.479,1.313 0.458,0.198 10 false CV+ 5.031,1.51 5.5,1.75 0.469,0.24 10 false CV- 5.021,1.896 5.542,2.115 0.521,0.219 10 false CGND 4.833,2.219 5.292,2.417 0.458,0.198 10 false T6 4.833,2.385 6.333,2.917 1.5,0.531 10 false Rear Television Camera Assembly 3.125,3.26 4.958,3.458 1.833,0.198 10 false *: Shielded 3.49,1.688 3.802,1.885 0.313,0.198 10 false *

PROCEDURE

1.CONFIRM MODEL
a.

Choose the model to be inspected.


Result:
Result Proceed to
for RHD before Oct. 2014, for LHD A
for RHD from Oct. 2014 B



A

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

B

5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the I154 radio and display receiver assembly connector.


b.

Disconnect the T6 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I154-7 (CA+) - T6-6 (CB+) Always Below 1 Ω
I154-8 (V+) - T6-3 (CV+) Always Below 1 Ω
I154-16 (V-) - T6-2 (CV-) Always Below 1 Ω
I154-15 (CGND) - T6-5 (CGND) Always Below 1 Ω
I154-7 (CA+) - Body ground Always 10 kΩ or higher
I154-8 (V+) - Body ground Always 10 kΩ or higher
I154-16 (V-) - Body ground Always 10 kΩ or higher
I154-15 (CGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.

Reconnect the I154 radio and display receiver assembly connector.


b.
E297306C01
1.427,0.5 1.885,0.76 0.458,0.26 0.719,1.063 1.333,1.594 false 0.896,2.469 1.354,1.823 false 0.188,0.156 0.5,0.313 0.313,0.156 10 false *a 0.385,0.927 0.958,1.208 0.573,0.281 10 false CA+ 0.448,2.427 1.021,2.708 0.573,0.281 10 false CGND 1.521,0.552 2.094,0.833 0.573,0.281 10 false I154
*a Component with harness connected
(Radio and Display Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I154-15 (CGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I154-7 (CA+) - I154-15 (CGND) Within 60 seconds of turning the ignition switch ACC 5.5 to 7.05 V



Result:
Proceed to
OK
NG



OK

4.INSPECT REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

4.INSPECT REAR TELEVISION CAMERA ASSEMBLY
a.

Reconnect the T6 rear television camera assembly connector.


b.
E297304C01
1.5,0.198 1.896,0.427 0.396,0.229 1.51,2.344 1.906,2.573 0.396,0.229 0.719,0.604 1.26,1.167 false 1.865,3.635 2.375,4.26 false 0.146,0.125 0.458,0.281 0.313,0.156 10 false *a 0.5,0.469 0.885,0.698 0.385,0.229 10 false V+ 2.354,4.271 2.969,4.542 0.615,0.271 10 false GND1 1.573,2.375 2.188,2.646 0.615,0.271 10 false I152 1.573,0.229 2.188,0.5 0.615,0.271 10 false I154
*a Component with harness connected
(Radio and Display Receiver Assembly)


E265840C01
0.823,2.073 1,2.073 1,2.073 1.125,1.583 false 1.479,2.063 1.344,2.063 1.344,2.063 1.229,1.479 false 0.781,4.167 0.958,4.167 0.958,4.167 1.156,3.594 false 1.521,4.125 1.385,4.125 1.385,4.125 1.271,3.542 false 0.229,0.229 0.542,0.427 0.313,0.198 10 *a 0.396,1.052 0.76,1.313 0.365,0.26 10 GND 0.396,3.208 0.76,3.469 0.365,0.26 10 GND 0.26,2.271 0.625,2.531 0.365,0.26 10 *b 0.646,4.073 1.01,4.333 0.365,0.26 10 *c 0.656,1.979 1.021,2.24 0.365,0.26 10 *c 1.51,1.969 1.875,2.229 0.365,0.26 10 *d 1.542,4.052 1.906,4.313 0.365,0.26 10 *d
*a Waveform 1 (camera lens is not covered, displaying an image)
*b Waveform 2 (camera lens is covered, blacking out the screen)
*c Synchronization Signal
*d Video Waveform


Using an oscilloscope, check the waveform of the rear television camera assembly.

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.


OK:

Waveform is similar to that shown in the illustration.


Item Content
Measurement terminal I154-8 (V+) - I152-7 (GND1)
Measurement setting 200 mV/DIV., 50 μs./DIV.
Condition Ignition switch ON, shift lever in R

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

OK

6.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

OK

7.INSPECT REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

7.INSPECT REAR TELEVISION CAMERA ASSEMBLY

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY