Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2011.10–2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0074094 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABC  Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABC Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete A beam axis inspection has not been performed. Blind spot monitor sensor LH

PROCEDURE

1.PERFORM BEAM AXIS INSPECTION
a.

Perform beam axis inspection using the intelligent tester.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

Body Electrical > Blind Spot Monitor Slave > Utility
Tester Display
BSM Slave Beam Axis Inspection
50005 314 4203

Result:
Proceed to
NEXT



NEXT

END