Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM19V0EQ _54 Brake _014591 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0076219 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1420  Acceleration Sensor Malfunction  


DESCRIPTION

This DTC is stored when the skid control ECU detects an abnormality in the difference between the acceleration sensor value and the control value estimated based on the yaw rate sensor, steering angle sensor and speed sensor signals.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1420 Acceleration Sensor Malfunction Difference between the acceleration sensor value and the control value estimated inside the skid control ECU is abnormal.
·

Sensor installation

·

Yaw rate and acceleration sensor (Airbag sensor assembly)



PROCEDURE

1.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
a.

Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The ECU should be tightened to the specified torque.

The ECU should not be installed in a tilted position.


HINT:

If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE



Result:
Proceed to
OK
NG



OK

NG