1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
w/o VSC: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o VSC)>PRECAUTION
w/ VSC: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE CONSOLE BOX ASSEMBLY
67914
4.REMOVE FRONT DOOR SCUFF PLATE LH
62112A
5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
62312B
6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
55318C
7.REMOVE INSTRUMENT SIDE PANEL LH
53601
8.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55432D
9.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
55432D
10.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)
67913
11.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
12.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62311B
13.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55317A
14.REMOVE INSTRUMENT SIDE PANEL RH
55607
15.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55303B
16.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
58916
17.REMOVE BOX BOTTOM MAT
58804A
18.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
58817A
19.REMOVE FRONT NO. 2 CONSOLE BOX INSERT
58816B
20.REMOVE CONSOLE BOX INSERT
58544A
21.REMOVE FLOOR CARPET BRACKET LH
58543B
22.REMOVE FLOOR CARPET BRACKET RH
58861B
23.REMOVE NO. 1 CONSOLE BOX DUCT
89170
24.REMOVE AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Turn back the carpet.
Disconnect the connectors from the airbag sensor assembly as shown in the illustration.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Remove the 3 bolts and airbag sensor assembly.